Can someone assist? I have a 22' Grady center console. The boat has
hydralic
trim tabs. I have sarched everywhere and cannot locate any fill tubes or
caps
to allow for topping off the fluids?







Assuming they're Bennett trim tabs, you need to follow the hydraulic lines into
the boat and look for the hydraulic control unit. or you could follow the
wiring harness back from the switch. It's a plastic box, approx 7 x 8 x 5 inch
unit that will have a plastic cover that lifts off the top. Look for a small
black rubber stopper at the base of the control unit which is on the top part
of the reaservoir (about 1/2 way down the side). That's where the hydraulic
fluid goes.

Where in the bilge or inner transom area it's located was up to the installer.
It could be anywhere.

Barry