I remove a small section of wood at a time using the air chisel. Maybe 3' x
4'.
The removed the screws, then scraped any remaining juck using a 4" wall
scraper.
Then injected the holes with WEST system to keep the WX out. WEST turned
out to be a poor choice because it is not compatable with polyester fillers
and
primer. So I have to use an epoxy filler and primer. Much harder to sand but
otherwise work great.

Doug

"Keith" wrote in message
...
So what did you do with the screw holes as you removed the deck? Something
temporary until the area was ready to refinish? I'm going to face this
someday... yeech.

--


Keith
__
"I feel sorry for people who don't drink. When they wake up in the
morning, that's as good as they're going to feel all day."--Dean Martin
"Lew Hodgett" wrote in message
ink.net...
Subject

About $2K minimum, a lot of dirty work, and at least 90 days for the
typical 40 ft boat.

Have fun.

Lew