I'll second this recommendation. It stays somewhat flexible, and even
gasoline can't clean it off your fingers, so you know it's right for the
job.

"Jonathan W" wrote in message news:4
...
One of the Permatex products. Can't remember which one, but I have used
to reassemble carburetor without a gasket. The labels are clear, though.

Jonathan

Doug Dotson wrote:
Hi Folks!

I have successfully removed the cleanout ports (3)
from my port fuel tank. Quite a mess in there!
When I put them back in, does anyone have any advice
on what sealant to use? They are submerged in fuel
most of the time.

Thanks!
Doug





--
I am building a Dudley Dix, Argie 10 for my daughter. Check it out:
http://home.comcast.net/~jonsailr