Ideally you should have one router for each router bit. :-) Unfortunately
I only have five routers and eight bases. Three PC 690s with various bases,
a big ELU plunge set up in the router table and a big Dewalt plunge that I
use to swing larger bits. Also have a B&D but that doesn't count.

The one I use most is the PC 690 with the D handle. I don't know if the
PC690 comes in a kit with the D handle and plunge bases but if it does that
would be my reocmendation.

I set the extra PC bases up with special fittings. One is a long radius jig
for cutting circles. I made an angle base for one, a scarfing jig for
another and the fourth is set up for inlays.

--
Glenn Ashmore

I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com

"Evan Gatehouse / Diane Selkirk" wrote in message
...
Hi all,

A bit of background:

I'm building a foam/stitched E-glass/carbon fiber/epoxy bridgedeck cabin
for
my 40' catamaran. I *think* I want/need a router to carve rebates in the
foam at edges where taping will occur and also in areas of high loaded
fittings where extra laminate will be applied to avoid lumps.

So now that I've justified my purchase of a router, I began to think of
what
else I could use it for on this and other projects. In the next year or
so
I'm going to be building the interior furniture for this cabin, and
re-doing
galley cabinets, among other projects.

I can see using a router to make profiles in hardwood to trim bulkeads,
round over openings in bin-type lockers, etc. Cut openings in the new
cabin
for recessed bonded in windows. The heaviest plywood on this boat is
going
to be 1/4" with lots of foam/glass cabinets and seating. Wood trim would
never exceed 1"x1". Building an icebox would be easier with one to shape
the lid openings.

I'm thinking a 1-3/4 HP plunge router would be my best choice; a laminate
trimmer seems pretty underpowered for what I may try to do? I'm not and
never will be a super wood worker type of person and envision a mostly
white
painted ply/composite interior with matching varnished hardwood trim to
match what is already existing on the boat. Budget is about $200+ USD

So my questions a

- what size of router is most appropriate for these jobs that I have
described?
- am I leaving out other obvious uses that may require a bigger one?
- weight is important since this tool would stay with me on the boat and
it's a catamaran where I try to keep things light - but should I consider
one of the plunge / fixed base router kits?

Thanks in advance for all your thoughts,


Evan Gatehouse
ceilydh **at** 3web **dot** net
---- rewrite my signature to send email