On Sun, 26 Dec 2004 20:30:59 -0500, "tcoop" wrote:

I have a 40 hp Force engine and it is leaking oil from between the prop and
carrier bearing housing assembly
http://coopscorner.com/takealook/carrier_assembly.htm

Can somone give me some hints on getting the carrier assembly off of the
lower gear caseing? Does it have little pins that it slides onto, does it
screw on, do i need a fancy wheel puller or do i need a big hammer and a
block of wood?

I have the 2 new oil seals, but I am wondering if there is an O ring that is
holding the carrier in place?

Thanks in advance for the help, it is very much appreciated....tom

If I were you, I'd get a Selock manual - however, just a guess, the
bearing is press fitted on the prop shaft. That requires some
patience if you don't have a hydraulic press.

Later,

Tom