On Fri, 29 Oct 2004 12:56:13 GMT, Jeff wrote:

Morgan Ohlson wrote in
news
On 28 Oct 2004 19:04:52 GMT, William R. Watt wrote:

Morgan Ohlson ) writes:
Can any one say which is the best way to get trustworthy panel
offsets out of that program Hull Designer ?

Link here (it's free):
http://www.carlsondesign.com/index.html#Fun_Shareware

I had problems figuring it out and didn't get a really good fit for
one model (www.ncf.ca/~ag384/Solo15.htm). I studied the numbers and
tried plotting cutting carboard panels a couple of times. When I
asked about it here people wrote they were able to use it to get good
fits.

Have you tried putting the data from Hull Design into Hullform and get
it outprinted that way?


If you have hullform why would you use hulls?

I think it's much easier to work with the graphical presentation in Hulls
Des.

....have all designs in hulls
....and that I have not learnt Hullform properly.


Morgan O.