Morgan Ohlson ) writes:
Can any one say which is the best way to get trustworthy panel offsets out
of that program Hull Designer ?

Link here (it's free): http://www.carlsondesign.com/index.html#Fun_Shareware

I had problems figuring it out and didn't get a really good fit for one
model (www.ncf.ca/~ag384/Solo15.htm). I studied the numbers and tried
plotting cutting carboard panels a couple of times. When I asked about it here
people wrote they were able to use it to get good fits.

--
------------------------------------------------------------------------------
William R Watt National Capital FreeNet Ottawa's free community network
homepage: www.ncf.ca/~ag384/top.htm
warning: non-FreeNet email must have "notspam" in subject or it's returned