Thread
:
has anyone been in a severe knockdown or capsize?
View Single Post
#
15
DSK
Posts: n/a
wrote:
Here's where your book learned, Walter Mitty knowledge dumps you on your ass,
Tougboat.
No, it's where the fact that
1- you are a sock puppet
2- you don't know **** from shinola
becomes obvious.
... Cold Molded IS plywood. It's just glued up over a boat shaped mold,
rather than as a flat sheet.
And was your FD cold molded?
... I find it hard to believe that you claim to know
about sailboats and don't even know something that basic. What did you think
cold molded was?
Knowledge of cold molding isn't essential to sailing, however I have
helped build cold molded boats... probably know at least a little about
it. I also know about hot molding, which is what your FD would be if it
was production built before about 1970.
You are correct that they were round bottomed.
I am also correct about the bailers.
"Plywood Flying Dutchman" is almost as good as "classic sunfish without
the sissy footwell."
DSK