jeffies, what is in that water? what happens to that stuff in that water when
the water stops flowing and evaporates? How much pressure do you think a raw
water pump produces? How much pressure is needed to raise water one foot? two
feet? three feet?

now remember, jeffies, *you* are telling the impressionable newbies on the ng
to do ALL this because *you* did not know until this morning that water
injection units are supposed to be mounted above the water line.

do you find your behavior morally reprehensible, jeffies? I do.

Jaxie, you don't know what you're talking about: If you have a vent hole on a
high loop, when the water is flowing, that keeps it clear; when the water
stops
it's a siphon break. Very simple, no moving parts, no clog. When you see
the
flow out the vent you know its not clogged. Its very simple, but obviously
beyond your limited capabilities.



"JAXAshby" wrote in message
...
you are hopeless jeffie. put that hose high enough not to be a siphon and
all
you have done is move the "plug up point" higher and into a point at which
at
high heel angles you do indeed have a siphon.

jeffies, this is *easy* stuff, as in E Z!!!!!!!


.What? Do you have any idea what a siphon is?? A small line squirting
water
into the air a foot above the water does NOT make a siphon! Jaxie, you
really
should look at a boat sometime. A real boat, not the toys in your
bathtub.


"JAXAshby" wrote in message
...
Or, you can just run the hose overboard. This way, a continuous stream
keeps
the line clear, and its easy to check that its working.

idiot, you just described a siphon.

jeffies, you really are too dumb to even be able to understand just how
dumb.
I hope to god no one takes your "advice" seriously, for they can get
hurt
doing
so. leave the talking, jeffies, to the adults.