On Thu, 23 Oct 2003 15:54:16 -0700, UglyDan®©™ wrote:

$50? for a cutlass bearing,After shaft removel, Drill out the set
screws, if you can't slide or punch it out, Get your hacksaw, take the
blade out, put the blade thru the where the shaft was, hook back up to
hack saw and cut till your thru the rubber and sleeve splitting it, use
a narrow flat tip screwdriver and pop/pry it out, Clean out the crap in
the strut, tap out the holes insert new bearing tighten up the set
screws and splash it, UD

Sounds like a Plan! Thanks.

Lloyd