Thread
:
Mercruiser Tilt/Trim Gauge always shows UP
View Single Post
#
2
posted to rec.boats
[email protected]
external usenet poster
First recorded activity by BoatBanter: Jul 2007
Posts: 36,387
Mercruiser Tilt/Trim Gauge always shows UP
On Tue, 4 Aug 2020 02:35:02 -0700 (PDT),
wrote:
Where should the trim guage sit with out drive fully down on mercruiser 3.0 petrol with alpha 2 sterndrive and new tilt and switch senders fitted
You need a meter. Check the sender, then check it at the gauge. There
is probably a short or open in the wire. I am not sure what "up" is on
the pot. You can test the gauge with a 200 ohm pot and a 33 ohm
resistor in series. That should sweep the gauge end to end if they
conform to the normal standard (~33-230). Connect ground and the input
through your resistor pot assembly.
Reply With Quote
[email protected]
View Public Profile
Find all posts by
[email protected]