Thread: boating today
View Single Post
  #4   Report Post  
posted to rec.boats
Bill[_12_] Bill[_12_] is offline
external usenet poster
 
First recorded activity by BoatBanter: Jan 2017
Posts: 4,553
Default boating today

wrote:
On Tue, 21 Jul 2020 22:16:44 -0000 (UTC), Bill
wrote:



Actual boat experience. Took the boat out to the Sacramento Delta and San
Joaquin River for a test. New starter, worked. Boat ran like crap when
starting. Gasoline smell. Had some gas around the water separator. When
I pulled the can to replace, I carry spares in the boat, there were 3 pin
hole corrosion holes on the back side. So, I assume the starting up run
like crap was air in the lines to the fuel injections. Ran great after
replacement and no gas fumes. Getting ready for a Donner lake trip.


I mask off the gasket and intake and shoot several coats of rustoleum
on those filter cans before I install them., They seem to last a lot
longer. I always replace them for rust long before the filter is
actually bad. I wish I could find some with an aluminum can.
I have an electric fuel pump up stream so a leak becomes apparent
pretty fast. I usually toss them at the first sign of a rust spot.


Can is maybe a year old. Had water in tank last year. Can looked good.
At least the side I could see. When I pulled the can, fuel was spitting
out. Is electric fuel pumps. Filter is after the low pressure pump.
AMA I did not have a bilge with 20 gallons of fuel the way the can leaked.
Maybe the wrench freed up the leaks.