On Tue, 27 Nov 2018 17:47:44 -0500, "Mr. Luddite"
wrote:

On 11/27/2018 5:22 PM, wrote:

I have a uniden CB radio (new) and have an existing larsen wb vhf radio already on my truck. Will this antenna work with my new radio.
Derek


Can't determine without knowing what freq range the truck antenna is
"cut" for. There are two VHF bands, low-band VHF (49-108 MHz),
high-band VHF (169-216 MHz). Marine radios operate in the high band.

Generally it will receive ok but transmit range may be limited due to
high standing wave ratio (SWR).

Even a marine VHF antenna should be tweaked in terms of length to
minimize SWR in the middle of the radio's freq range.


He is talking about CB (27mz) so that is over twice the wavelength of
the lowest frequency VHF.
SWR is really going to be ugly but since they are capped at 5w,
(usually more like 4.5) I doubt the magic smoke comes out but he won't
be "getting out" far either.

If his "truck" is a real one (breaker good buddy size) and he has 8-9'
from mirror to mirror the best antenna is the co phasers you see on
big rigs. Otherwise it is hard to beat a bottom coil loaded ~48"
antenna right in the center of the roof. That is what I had on my van
but you had to remember to take off the vertical when you went into a
parking garage. ;-)