An alternate method includes Rum drinks and a large "C" clamp. Tighten the
set screws as far as you can, attach the "C" Clamp and tighten it. Then
alternatively recheck the zinc set screws until done.
Less likely you'll knock the strut out of alignment and you don't need to be
any stronger than the clamp screw. The Rum is meant as an advanced reward
for a job well done.

"Bob" wrote in message ...
Yep hammer tapping.

Rob wrote:
--

Employed by Muller Marine Annapolis Md. Marine Worker, Composer, Artist
http://www.toad.net/~crm Check out my Galleries
and http://www.toad.net/~crm/neighborhood/index.htm "Peek into my
neighborhood"
Jeeper! [Nelly Belle] [0||||0] YJ 93 Bob's your Uncle.