On Wed, 26 Aug 2015 12:44:26 -0400, Keyser Söze
wrote:

On 8/26/15 12:32 PM, wrote:
On Wed, 26 Aug 2015 12:18:10 -0400, Keyser Söze
wrote:

On 8/26/15 12:03 PM, wrote:
On Wed, 26 Aug 2015 11:09:33 -0400, Keyser Söze
wrote:

On 8/26/15 11:07 AM, wrote:
On Wed, 26 Aug 2015 05:22:58 -0700 (PDT), Tim
wrote:

I have shot one several times. Its angry. Especially at $3. A pull

That is why I say a guy with one, should be reloading. With revolvers,
recovering the brass is not even hard.


It's a buck and a half a shot with factory loads. What's you guess about
reloading, assuming you recycled the brass a few times and were buying
readymade bullets?

You will run into the same issue with bullets as Tim was referencing,
small production runs but a buck a pop would not surprise me for a
performance bullet. Cast bullets should be a lot cheaper., maybe 30-40
cents, way less if you cast your own.. Primers and powder are pennies
a shot.
These hand cannons remind me of the chopper (motorcycles) that were
popular in the 70s. When I questioned the tiny gas tank, the guy said
"if you go that far you will want to get off anyway".
I doubt anyone is going to shoot a lot of full power loads.

I looked a little and there are some "cowboy" loads that push out
subsonic cast bullets and should shoot fairly easy.

The full power load is at least 3-4 times the energy.


I pay about 30 cents a round for decent factory 158 grain .357 MAG
rounds, similar to what I pay for .223 rifle ammo. That seems enough to
spend on ammo to me.

The .500 S&W is not your regular plinker.
It is like comparing a Bugatti to a Camry


Why would you want to "plink" with it, unless you are into hurting your
wrist/arm and annoying everyone around you?

I think that was what I said ;-)

If you shot the cowboy rounds out of it, you would save yourself a lot
of punishment.
I don't think a .357 is a plinker either, unless you are shooting .38
wad cutters out of it. That was the round I loaded most often. A 148gr
wc in front of about 2.5 gr of Bullseye was a very pleasant load to
shoot, very accurate and easy on the brass.
If I was loading a full power .357 round, the brass takes a beating,
along with the shooter. I was loading some stuff that was a bit hotter
than anything you could buy. I had a 125gr round nose half jacket that
was going 1725 FPS. That is smoking for a .357. It was not pleasant to
shoot tho and I threw the brass away.