On 12/29/14 5:20 PM, wrote:
On Mon, 29 Dec 2014 15:44:11 -0500, Keyser Söze
wrote:

On 12/29/14 1:00 AM, wrote:
On Sun, 28 Dec 2014 14:01:53 -0500, Keyser Söze
wrote:

On 12/28/14 1:46 PM, Tim wrote:
On Sunday, December 28, 2014 10:09:01 AM UTC-8, wrote:
On Sat, 27 Dec 2014 19:56:39 -0500, Keyser Söze
wrote:

... .22lr DA revolver. Plan to shorten barrel to 4" and have it
threaded. Don't want to buy new revolver and sacrifice barrel.
From you to my FFL to me.

Why would you bother to put a suppressor on a revolver? Science fair
project?
The only one that was reasonably successful was the Dan Wesson with
the adjustable cylinder gap as far as I know.
You would be better off getting one of those Ruger MKs we keep talking
about. I know they are "BB gun" quiet with a decent suppressor

Or get an 1895 Nagant-no modification necessary

https://www.youtube.com/watch?v=vvF4yurWSc0



Found a threaded barrel for my Ruger Mark III. Don't know if it has a
serial number. Left email for the seller.

A barrel is just a maintenance part. It is the receiver of the gun or
the suppressor can that is serialized.
If you can get that threaded barrel and it is the same thread as your
can you are good to go and you will ne a lot happier than you would be
with a regular revolver.



The serial number on the Mark III is on the upper, not the lower
receiver. The upper taps off in one piece, including the barrel:

http://tinyurl.com/qdxxqt8


You are right, the Mk III does use a pressed in barrel and it is not
easily freed from the receiver or replaced.
I just saw ads for them and thought it was a regular screw in deal.
There are companies that will sell you a whole new upper but I am not
sure how you deal with the serial number.
What would your gun smith want to thread yours?

Around here a new serialized assembly goes through an FFL.

My AR15/22 came with a properly threaded barrel and functions properly
with a suppressor:

https://www.youtube.com/watch?v=qCvAPIgi9nw

Threading the pistol barrel is $125-$150, typically