BoatBanter.com - View Single Post

Wayne.B

On Thu, 26 Jun 2014 22:41:20 -0400, KC wrote:

On 6/26/2014 10:15 PM, wrote:
On Wed, 25 Jun 2014 19:08:07 -0400, F*O*A*D wrote:

On 6/25/14, 6:56 PM, wrote:
On Wed, 25 Jun 2014 13:31:32 -0400, H*a*r*r*o*l*d
wrote:

My gawd you're right. It would be unthinkable to bend the rules and hook
two extension cords together.

If you are using those cheap 16 ga cords, you might not get enough out
the far end to run a chain saw

I'm sure there is a significant voltage drop with the heavier 100' cord
I have. I bought it to run an electric string trimmer, and I noticed it
wasn't as peppy when I plugged it into the long cord. That's when I
bought the two cycle trimmer.

A contractor grade cord (12ga) will drop a tad over 5 volts 100 feet
out with a 13a load, what a good chain saw might draw.
That is less than the recommended max V/D.

In order to avoid zoning issues at the boat shop I ran everything off
two 100 foot, 12 gauge extension cords. They ran everything I threw at
them including my Table Saw and Radial Arm. I had them each plugged into
dedicated lines from the fuse box. Never noticed any problem with them
and any loss of power at the plug.

===

I used to have a 250 ft 10 gauge extension cord that I built myself
from a roll of 12/3 romex cable. It was stored on a garden hose reel
for ease of deployment and to avoid kinking. It was very useful in
winter storage boatyards where the boat ended up being a long way from
an outlet box. I could run electric heaters and any power tool that I
wanted from it.