Gear shift cable
 

Hi everybody:

Anyone ever had to replace the gear shift cable on a Volvo Penta 270
outdrive.....with the boat in the water? Single, standard Morse cable
(screwed both ends) about 4 metres long. 2 Litre Volvo AQ125 engine (in line
OHC)

Outdrive has a hose/sleeve mounted to inside frame of drive (engine
compartment side) through which the cable passes to the outside. This sleeve
has bends that have too tight a radius to allow the rigid end of the cable
to pass through...so presumably needs to be removed, the cable threaded
through to the outside leg and then the sleeve installed over the cable and
secured to the frame ( male screw fitting) Can't see and can't find any info
on this set up so not sure if I remove this sleeve if I open a 1 inch hole
in the boat below the waterline.

I'd sure like to hear from anyone with any experience of this.

Thanks
Bob