Glastron Alpha Mod 159RD Sail Boat
 

I recently picked up a Glastron Alpha which will need a large amount
of work to make it usable. I plan on making it yet another one of my
"projects". There is a large amount of gel coat cracking, 3 patches
that either Daryl or his other brother daryl attempted to do, and is
in need of a new sail.

Right now am unsure if it is even worthwhile to refurbish but am in
the research stage. So far I have not been able to locate any
information about the internal structure of the boat such as whether
or not there is any wood underneath the glass anywhere, how the boat
is constructed, ect. Assuming I go forward with this little project I
will need to locate some parts such as the edge rail, perhaps
replacement rudder and center board and the like.

As I said I am just doing some research right now but any info you
might know would be appreciated.


Thanks

Tom

--
Posted at author's request, using moderated http://www.BoatForumz.com interface
Thread archive: http://www.BoatForumz.com/Glastron-A...pict21294.html

Glastron Alpha Mod 159RD Sail Boat
 

"Tom" wrote in message
news:150403_c0b5f1cd5133a77785279408dd5c3f6e@boatf orumz.com...
I recently picked up a Glastron Alpha which will need a large amount
of work to make it usable. I plan on making it yet another one of my
"projects". There is a large amount of gel coat cracking, 3 patches
that either Daryl or his other brother daryl attempted to do, and is
in need of a new sail.

Right now am unsure if it is even worthwhile to refurbish but am in
the research stage. So far I have not been able to locate any
information about the internal structure of the boat such as whether
or not there is any wood underneath the glass anywhere, how the boat
is constructed, ect. Assuming I go forward with this little project I
will need to locate some parts such as the edge rail, perhaps
replacement rudder and center board and the like.

As I said I am just doing some research right now but any info you
might know would be appreciated.


Thanks

Tom

--
Posted at author's request, using moderated http://www.BoatForumz.com
interface
Thread archive:
http://www.BoatForumz.com/Glastron-A...pict21294.html

This group mostly does power boating though there are a few sailboaters
occasionally. In general most fiberglass boats up until fairly recently
used wood as the foundation for a lot of structural components such as the
stringers, floor, deck, and transom. Even today it is common but a few are
beginning to realize that composite materials are not going to eventually
rot like wood. Before embarking on extensive work I suggest to try to
locate areas that might contain wood. It's ok to drill test holes. If you
pull up wet wood mush then you might have issues. Fill test holes with an
epoxy/chopped glass filler mix to close.