Home |
Search |
Today's Posts |
#8
![]() |
|||
|
|||
![]()
Your leak "at the bottom" of the outdrive may be a rotten transom......
Bill "Terry Rago" wrote in message news:MJlJc.82343$%_6.81673@attbi_s01... I have twin 3.7's and what you describe is a common problem for these. The leak in normally between the manifold and reservoir. It usually means that you have to replace the reservoir and the gasket. If you pull the #4 plug you will probably see that the piston in that cylinder looks very clean on top. That is because that is the first cylinder it leaks into. Mine broke the piston in half before I paid attention to it. You might want to check it a little sooner to save LOTS of money. Terry "Ree-Yees" wrote in message news ![]() Two minor prods with the 1987 Sea Ray. It has a 3.7 liter mercruiser I/O engine with a closed coolant system. So I have a antifreeze tank, overflow tank, and a big cylinder on the side that antifreeze and water runs through. To keep the antifreeze in the overflow tank between the add and full lines I usually have to add in one to three cups of coolant into it each time I take the boat out. I can start the boat up and turn it on and off and run it for a while in the yard and the coolant amount stays the same and no smoke comes out the back. When I take it out on the lake and I turn it off in the water and let it sit there for any amount of time more than a minute or so, and then start it up a bunch of whitish smoke comes out of the back appearing to come from the exhaust. It smells like exhaust with a hint of antifreeze. This is where I am losing the coolant, but I dont know where its leaking at. Oil is not milky and this problem has stayed consistant for the whole summer so far. The second problem that may or may not be related to the first problem is that I have a leak in hte boat. The leak is down at the bottom of where the outboard peice comes through the transom. The leak is not big enough to make the bilge pump run for for a little bit every once in a while, but water is definitly coming in. To get to whatever is leaking the outboard peice is going to have to come off. How much to places usually charge for such a task? Thanks for any info you got! Cameron |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
fiberglass pontoon leak on boat slip, HELP! | General | |||
Boat fell off trailer | General | |||
Many boats are not being used. | General |