Merc 9.9 STILL not right
 

Well, I got my brand-new 9.9 4-stroke back from the Dealer yesterday. It was in
because it was hard-starting (for a NEW motor), idled rough, and had a "lag" at
about 1/3 throttle. Put it on the boat (12-ft aluminum skiff) and tried it out
on the river.

No change. Seems like they brought the idle speed up a bit. THEY claim it's not
supposed to start cold on idle. *I* claim just about every other brand-new
engine I've ever used does, so why not an outboard? Right now, if you bring the
throttle up a bit (you have to press the "high-idle" button since the shifter is
built-in to the twist-grip throttle), it will start after a few pulls. They also
say there's some kind of over-ride on the choke button, since it doesn't seem to
make any difference: is this right, or is it simply NOT CONNECTED??

Now, with the idle speed up, it idles well in neutral, but shakes the whole boat
when running in fwd at idle (like when trolling...). I'm assuming this isn't
right?

Finally, the "lag" is still there. It's not really noticable if you just crank
the throttle from idle to "planing speed", but if you slowly go up, there's a
place the engine almost stalls before going back up again. Normal? I sure hope
not!

It IS a sweet motor: up on plane, it's quiet and smooth, and seems to have at
least as much power as the old Johnson 15. And NO pollution! :)

Any suggestions? different dealer? Contact Mercury directly? My wife (who didn't
like me dropping $2800 on THAT new motor 6 mos after spending $10K on a new
motor for Far Cove), wants me to take it back and get my money back. I don't
think that's possible...

Lloyd Sumpter
"Skeeder" Mirrocraft 12

Merc 9.9 STILL not right
 

wants me to take it back and get my money back. I don't
think that's possible...

It definetly isn't possible to get your money back if you don't insist on
it.

Merc 9.9 STILL not right
 

On Sat, 03 Jul 2004 08:40:50 -0700, "Lloyd Sumpter"
wrote:


Well, I got my brand-new 9.9 4-stroke back from the Dealer yesterday. It was in
because it was hard-starting (for a NEW motor), idled rough, and had a "lag" at
about 1/3 throttle. Put it on the boat (12-ft aluminum skiff) and tried it out
on the river.

No change. Seems like they brought the idle speed up a bit. THEY claim it's not
supposed to start cold on idle. *I* claim just about every other brand-new
engine I've ever used does, so why not an outboard? Right now, if you bring the
throttle up a bit (you have to press the "high-idle" button since the shifter is
built-in to the twist-grip throttle), it will start after a few pulls. They also
say there's some kind of over-ride on the choke button, since it doesn't seem to
make any difference: is this right, or is it simply NOT CONNECTED??

Now, with the idle speed up, it idles well in neutral, but shakes the whole boat
when running in fwd at idle (like when trolling...). I'm assuming this isn't
right?

Finally, the "lag" is still there. It's not really noticable if you just crank
the throttle from idle to "planing speed", but if you slowly go up, there's a
place the engine almost stalls before going back up again. Normal? I sure hope
not!

It IS a sweet motor: up on plane, it's quiet and smooth, and seems to have at
least as much power as the old Johnson 15. And NO pollution! :)

Any suggestions? different dealer? Contact Mercury directly? My wife (who didn't
like me dropping $2800 on THAT new motor 6 mos after spending $10K on a new
motor for Far Cove), wants me to take it back and get my money back. I don't
think that's possible...

Lloyd Sumpter
"Skeeder" Mirrocraft 12



I would try dropping the manufacturer a letter (registered mail) and
include your email address. You might want to point them to this news
group too, and explain that their brand is getting negative publicity,
not only in what you expect from their product, but also in its
service department. If nothing else, the dealer might get a call from
the "Ivory Tower". Include the quotes from the dealer etc. etc. and
see what they say.
Who knows, they might just come through for you.