![]() |
|
electric marine hot water heaters
"Bob D." wrote in message ... Sorry, Gould. Bad day. Still, my point is made. The idea is that heat exchangers are to allow use of the system when the boat is not tied to shore power. Perhaps this prevelance is influenced by geography, but I've seen this type of system on more sailboats than powerboats of comparable size. These observations support my statement that this setup is more prevelant in sailboats. Sailboats are more likely to be underway for longer periods of time and are more likely to be anchoring without ammenities. Add to that my statement was in response to a powerboater who has never heard of such a system and it supports my viewpoint... You point out the obvious that these can be used on powerboats as well. Your personal observations may disagree with my statement that the system is more prevelant among sailboats, but your just picking nits. Bob Dimond A lot of the tournament ski boats have heat exchanger showers. Would skew the numbers away from sailboats. |
electric marine hot water heaters
In all honesty, I'll have to check if mine has an exchanger inlets when I
get up to the boat. It's a six gallon unit, and I didn't think it did. I know my dad's 6 gallon system is not hooked in either. Whether his tank has the capacity to run off the engine, I don't know. Do alot of power boats in the 40' in under range in your area use the engine? Many of the ones I've seen in the great lakes region did not. In article , (Gould 0738) wrote: Can you even buy an electric marine hot water heater that isn't pre-plumbed with a heating coil? In cases where such a heater is installed in a boat that doesn't have a closed cooling system, I usually see the fittings for the coil capped off. I have seen some household type water heaters stuffed into the bilges of Cruise-a-homes and outboard powered boats with shorepower conections. The vast majority of time they rot out very prematurely. |
electric marine hot water heaters
Can you even buy an electric marine hot water heater that isn't pre-plumbed
with a heating coil? In cases where such a heater is installed in a boat that doesn't have a closed cooling system, I usually see the fittings for the coil capped off. I have seen some household type water heaters stuffed into the bilges of Cruise-a-homes and outboard powered boats with shorepower conections. The vast majority of time they rot out very prematurely. |
electric marine hot water heaters
On Wed, 16 Jun 2004 14:51:46 -0400, (Bob
D.) wrote: Do alot of power boats in the 40' in under range in your area use the engine? Many of the ones I've seen in the great lakes region did not. ===================================== The key is closed cooling systems. On the great lakes closed cooling may be less common. In salt water areas, just the opposite. |
electric marine hot water heaters
While wally is right on both counts, I still wonder if a water heater
hooked into a raw water cooling system is more of an exception than a rule. If the majority of powerboats have wally's setup, then perhaps my experience with powerboat systems is more limited than I thought. Either way, since Wally posted on the topic he is obliged to helpme fix the problem based on the little known usenet 1000 meter proximity rule, with beers at the Vikings Den to be rendered as payment :^) Bob Dimond In article , To wrote: On Thu, 17 Jun 2004 14:14:25 GMT, WaIIy wrote: On Wed, 16 Jun 2004 21:29:08 -0400, Wayne.B wrote: On Wed, 16 Jun 2004 14:51:46 -0400, (Bob D.) wrote: Do alot of power boats in the 40' in under range in your area use the engine? Many of the ones I've seen in the great lakes region did not. ===================================== The key is closed cooling systems. On the great lakes closed cooling may be less common. In salt water areas, just the opposite. Why is that the key? My 29 ft SeaRay had raw water cooling and was hooked up to the water heater. Worked great. The engines heat up to around 150-175 degrees no matter if you have raw cooling or fresh cooling. Note : Great Lakes comment since corrosion inside the water heater is nil. |
electric marine hot water heaters
Hey Wally!
Sorry I missed your response. I went out late Friday afternoon and Returned Saturday and Sunday to remove the outdrive and scrub out the cabin. As you come down the small hill the boat is on the immediate right, across from the PWC docks. It is a white hull with a aqua-marine gel-cote stripe. It is dry docked next to the fabled 42 foot Sea Ray that came in last fall with half of the bottom town off. BTW - What is the story with that boat. do you know? If you see a car parked off to the right, stop by and say hi. The frige is working, so I have cold beer and pop. Bob Dimond In article , To wrote: On Thu, 17 Jun 2004 09:56:27 -0400, (Bob D.) wrote: While wally is right on both counts, I still wonder if a water heater hooked into a raw water cooling system is more of an exception than a rule. If the majority of powerboats have wally's setup, then perhaps my experience with powerboat systems is more limited than I thought. Either way, since Wally posted on the topic he is obliged to helpme fix the problem based on the little known usenet 1000 meter proximity rule, with beers at the Vikings Den to be rendered as payment :^) Bob Dimond Hey Bob, I was out there today and probably will be tomorrow. I'm finally getting the thing in shape. Where is your boat and when will you be out there? I carry a fair amount of tools with me. |
All times are GMT +1. The time now is 01:21 PM. |
|
Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 BoatBanter.com