Question for you electronics wizards...>>>
 

I'm running 2 12-volt batteries running in series to power my 24-volt
electric motor in my jon boat (on an electric-only reservoir) and I want to
run a fish finder. Here's my question -- can I safely run the fish finder
off of one of the 2 12-volt batteries while running the 24-volt motor? Or,
is that going to burn up the fish finder? Should I just invest in a couple
of 6-volt lantern batteries instead?

--
Marty S.
Baltimore, MD USA

Question for you electronics wizards...>>>
 

On Tue, 8 Jun 2004 21:17:33 -0400, "Marty S." wrote:

I'm running 2 12-volt batteries running in series to power my 24-volt
electric motor in my jon boat (on an electric-only reservoir) and I want to
run a fish finder. Here's my question -- can I safely run the fish finder
off of one of the 2 12-volt batteries while running the 24-volt motor? Or,
is that going to burn up the fish finder? Should I just invest in a couple
of 6-volt lantern batteries instead?

One of the batteries is referenced to GROUND, the other is not.

If you connect your fish finder across the battery that is referenced to
GROUND, you should be fine. If you make the mistake of connecting across the
*other* battery, what the fish finder "thinks" is GROUND will actually be 12
volts *above* GROUND, which sooner or later will be revealed to be A Bad
Thing...

/daytripper

Question for you electronics wizards...>>>
 

Your fish finder will be fine across one of the batteries. If you're
hesitant, apply (or borrow) your voltmeter across either of the batteries.
You'll find it reads ... 12 volts.


"Marty S." wrote in message
...
I'm running 2 12-volt batteries running in series to power my 24-volt
electric motor in my jon boat (on an electric-only reservoir) and I want
to
run a fish finder. Here's my question -- can I safely run the fish finder
off of one of the 2 12-volt batteries while running the 24-volt motor?
Or,
is that going to burn up the fish finder? Should I just invest in a
couple
of 6-volt lantern batteries instead?

--
Marty S.
Baltimore, MD USA

Question for you electronics wizards...>>>
 

"daytripper" wrote in message
...
On Tue, 8 Jun 2004 21:17:33 -0400, "Marty S."
wrote:

I'm running 2 12-volt batteries running in series to power my 24-volt
electric motor in my jon boat (on an electric-only reservoir) and I
want to
run a fish finder. Here's my question -- can I safely run the fish
finder
off of one of the 2 12-volt batteries while running the 24-volt
motor? Or,
is that going to burn up the fish finder? Should I just invest in a
couple
of 6-volt lantern batteries instead?

One of the batteries is referenced to GROUND, the other is not.

If you connect your fish finder across the battery that is referenced
to
GROUND, you should be fine. If you make the mistake of connecting
across the
*other* battery, what the fish finder "thinks" is GROUND will actually
be 12
volts *above* GROUND, which sooner or later will be revealed to be A
Bad
Thing...

/daytripper

Near as I can tell in my boat, neither side of the batteries for the
trolling motor is ground. The trolling motor basically floats. So go
ahead. use the battery connected to ground if one of them is connected
to ground.

del cecchi.

Question for you electronics wizards...>>>
 

I'm not sure about your answer, Daytripper. I don't have either battery
connected to ground as far as I know. The + terminal of one battery goes to
the motor, and the - terminal of the other battery goes to the motor, and
the other terminals are connected to each other so the battery is connected
in series.

--
Marty S.
Baltimore, MD USA


"daytripper" wrote in message
...
On Tue, 8 Jun 2004 21:17:33 -0400, "Marty S." wrote:

I'm running 2 12-volt batteries running in series to power my 24-volt
electric motor in my jon boat (on an electric-only reservoir) and I want
to
run a fish finder. Here's my question -- can I safely run the fish
finder
off of one of the 2 12-volt batteries while running the 24-volt motor?
Or,
is that going to burn up the fish finder? Should I just invest in a
couple
of 6-volt lantern batteries instead?

One of the batteries is referenced to GROUND, the other is not.

If you connect your fish finder across the battery that is referenced to
GROUND, you should be fine. If you make the mistake of connecting across
the
*other* battery, what the fish finder "thinks" is GROUND will actually be
12
volts *above* GROUND, which sooner or later will be revealed to be A Bad
Thing...

/daytripper

Question for you electronics wizards...>>>
 

I've checked the voltage and either battery by itself reads 12 volts when
hooked up in series, and they are 24 together. However, is there an issue
of amps or watts or current or whatever else flows in the wires? The fish
finder draws about 110 milliamps (whatever that is)... Will it burn out or
crack or implode or fizz out or whatever? (as you can tell, I didn't spend
a whole lot of time paying attention in 7th grade electrical shop)

--
Marty S.
Baltimore, MD USA


"Bowgus" wrote in message
. rogers.com...
Your fish finder will be fine across one of the batteries. If you're
hesitant, apply (or borrow) your voltmeter across either of the batteries.
You'll find it reads ... 12 volts.


"Marty S." wrote in message
...
I'm running 2 12-volt batteries running in series to power my 24-volt
electric motor in my jon boat (on an electric-only reservoir) and I want
to
run a fish finder. Here's my question -- can I safely run the fish
finder
off of one of the 2 12-volt batteries while running the 24-volt motor?
Or,
is that going to burn up the fish finder? Should I just invest in a
couple
of 6-volt lantern batteries instead?

--
Marty S.
Baltimore, MD USA

Question for you electronics wizards...>>>
 

On Tue, 8 Jun 2004 22:55:51 -0400, "Marty S." wrote:

I'm not sure about your answer, Daytripper. I don't have either battery
connected to ground as far as I know. The + terminal of one battery goes to
the motor, and the - terminal of the other battery goes to the motor, and
the other terminals are connected to each other so the battery is connected
in series.

Might help to draw this out.

A typical 12v wiring job on a boat with an electric starter (at least), some
part of the motor is connected to the negative pole of the 12v battery. That
would be the moral equivalent to "earth ground" on a boat.

The electronics are referenced to the same potential, and things like antenna
ground and lighting fixtures may be referenced to that same potential, as it
is the return path for all powered things on the boat.

Shifting that potential by connecting the negative pole of the original
battery to the positive pole of the first battery (and then connecting the
negative pole of the second battery to the negative terminal of the trolling
motor) runs a certain risk different current return paths at different
potentials coming in contact with each other. Ie: if the exterior of the
trolling motor is connected to its negative terminal, when the motor is in the
water there could be current flowing through the *boat* motor (which is
connected to the negative pole of the original battery).

That wouldn't be good, I suspect ;-)

/daytripper

Question for you electronics wizards...>>>
 

You should have no problems. The only issue and it is a minor one is that
your batteries will be discharged unevenly. If you aren't running them
almost all the way down before recharging there should be no problem what so
ever.

--
Public Fishing & Boating Forums
Fishing & Boating Link Index
www.YumaBassMan.com


"Marty S." wrote in message
...
I'm running 2 12-volt batteries running in series to power my 24-volt
electric motor in my jon boat (on an electric-only reservoir) and I want
to
run a fish finder. Here's my question -- can I safely run the fish finder
off of one of the 2 12-volt batteries while running the 24-volt motor?
Or,
is that going to burn up the fish finder? Should I just invest in a
couple
of 6-volt lantern batteries instead?

--
Marty S.
Baltimore, MD USA

Question for you electronics wizards...>>>
 

Daytripper: I don't have two motors. This is just a small jon boat powered
by an 24-volt electric trolling motor with 2 batteries connected in series.

--
Marty S.
Baltimore, MD USA


"daytripper" wrote in message
...
On Tue, 8 Jun 2004 22:55:51 -0400, "Marty S." wrote:

I'm not sure about your answer, Daytripper. I don't have either battery
connected to ground as far as I know. The + terminal of one battery goes
to
the motor, and the - terminal of the other battery goes to the motor, and
the other terminals are connected to each other so the battery is
connected
in series.

Might help to draw this out.

A typical 12v wiring job on a boat with an electric starter (at least),
some
part of the motor is connected to the negative pole of the 12v battery.
That
would be the moral equivalent to "earth ground" on a boat.

The electronics are referenced to the same potential, and things like
antenna
ground and lighting fixtures may be referenced to that same potential, as
it
is the return path for all powered things on the boat.

Shifting that potential by connecting the negative pole of the original
battery to the positive pole of the first battery (and then connecting the
negative pole of the second battery to the negative terminal of the
trolling
motor) runs a certain risk different current return paths at different
potentials coming in contact with each other. Ie: if the exterior of the
trolling motor is connected to its negative terminal, when the motor is in
the
water there could be current flowing through the *boat* motor (which is
connected to the negative pole of the original battery).

That wouldn't be good, I suspect ;-)

/daytripper

Question for you electronics wizards...>>>
 

"Marty S." wrote in message
...
I'm running 2 12-volt batteries running in series to power my 24-volt
electric motor in my jon boat (on an electric-only reservoir) and I want
to
run a fish finder. Here's my question -- can I safely run the fish
finder
off of one of the 2 12-volt batteries while running the 24-volt motor?
Or,
is that going to burn up the fish finder? Should I just invest in a
couple
of 6-volt lantern batteries instead?



The easiest way to hook them up so you will not have electrical interaction
problems is to attach the negative wire of the fish finder to the same
battery terminal as the negative wire of the trolling motor. That way both
items use the same "ground" path.

Bill Grannis
service manager