LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #6   Report Post  
Tony Thomas
 
Posts: n/a
Default Priming a jet boat?

Jet Ski's are gravity feed so no fuel bubble is required to prime. Yours
(not really a jet ski) would either have a fuel pump (mechanical or
electrical) or be gravity feed. If you turn the key on and can hear a pump
running, then it is electric. If the fuel line is routed such that the
lowest point is the input to the engine, then it is gravity feed. Otherwise
it has a mechanical fuel pump that runs off the engine.
I would get a fuel bubble for an outboard and install a fitting on the
intake side that will allow me to insert the assembly into the system.
Prime and crank at home. Then remove the bubble assembly. This should get
you going. Other option would be to have the dealer install an electric
fuel pump. This will be costly and probably not worth the effort.
You might actually have a choke on the system. Can the key/ignition
assembly be pushed in any. If so, this is the choke. I also assume you are
using the cold start to increase throttle while trying to crank. Increase
throttle to wide open and then be ready to pull back once it cranks.


Tony
My boats and autos - http://t.thomas.home.mchsi.com



"Ragdoll" wrote in message
...

"RG" wrote in message
news:W2jUa.18913$Bp2.11778@fed1read07...

Your little 90hp Merc inboard is really an outboard motor, mounted

inboard.
And since it is an outboard motor, that means I know next to nothing

about
it. However, I do know that many outboard motors of that size often

have
a
sqeezeable primer bulb in the fuel line between the tank and the motor.

Not
sure if your Sea Rayder has one, but it wouldn't surprise me if it did.

I
suspect your dealer is telling you to squeeze the primer bulb to prime

the
motor with fuel. Look for a black egg-shaped rubbery bulb, probably

close
to the fuel pump. Squeeze the bulb multiple times until you start to

feel
pressure building in the bulb. Then try and start the motor.



Although Boatriger's post seems to suggest that there is no 'bulb', we'll
certainly look for one, anyway. I've read about the 'pumping' on some
info for outboards. My darling husband pointed out that this is a 120hp,
not a 90hp, but I seriously doubt that's relevant. This little boat is
basically a big, fat waverunner. ;-) Thanks so much for your time.
We really appreciate the response!

Rags





 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Why So Few Pontoon Boat Ads? Jay Chan General 32 August 4th 03 08:16 PM
Replacing part of the boat floor.... HELP!! [email protected] General 6 July 29th 03 10:46 PM
Boat pulling to left really bad noah General 1 July 13th 03 02:43 PM
Boat illegally docked? Chuck Tribolet General 5 July 11th 03 10:52 PM
Composite flooring on pontoon boat? Calif Bill General 3 July 1st 03 03:42 AM


All times are GMT +1. The time now is 01:22 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 BoatBanter.com.
The comments are property of their posters.
 

About Us

"It's about Boats"

 

Copyright © 2017