Home |
Search |
Today's Posts |
#2
![]() |
|||
|
|||
![]()
My 60 big foot uses the same pump as a 90 2 stroke. I mapped the water pressure
with a good guage, right after an extensive cooling system repair. (part of a longer story) It tops out at about 17-18 at WOT, 14 at 4400, 10 would be about 2800-3000. At idle it will be 3-4 but when coming down from speed it will be lower until the thermostat closes a bit. This is at the water jacket right above the raw water inlet tube where the fuel cooler taps off. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
rec.boats.paddle sea kayaking FAQ | General | |||
push vs pull vis a vis rudders | Cruising | |||
rec.boats.paddle sea kayaking FAQ | General | |||
rec.boats.paddle sea kayaking FAQ | General | |||
Usage of motoroil | General |