I recently purchased a 3 HP Sea King outboard motor. The Model # is:
GG9006A The serial # is: 75X668945 The year is unknown.

It seems to run good, although I can't really tell because it will not
pump water. I dis-assembled the lower unit and checked the pump.
This pump is like no other I have ever seen. It is a one piece, round
rubber ring with a straight 'nipple' extending from it to secure it in
place. It appears that the eccentric steel cam inside the centr of
the rubber causes water to be forced around the outside of the ring
(inside the housing) and into the tube feeding the cooling chambers.

The rubber ring is too large for the application. Either it has
swelled, or the previous owner installed the wrong size. There is too
much 'slack' in the ID and the ecentric will does not touch the
rubber. Also, the OD fits tight against the housing.

Can anyone tell me where I might purchase the correct size pump for
this model? Are there outlets for these old parts? Does any one have
a manual on this model?

TIA for all responses.

Joe in Tennessee

On 10 Nov 2004 05:43:54 -0800, (JCW) wrote:

I recently purchased a 3 HP Sea King outboard motor. The Model # is:
GG9006A The serial # is: 75X668945 The year is unknown.

It seems to run good, although I can't really tell because it will not
pump water. I dis-assembled the lower unit and checked the pump.
This pump is like no other I have ever seen. It is a one piece, round
rubber ring with a straight 'nipple' extending from it to secure it in
place. It appears that the eccentric steel cam inside the centr of
the rubber causes water to be forced around the outside of the ring
(inside the housing) and into the tube feeding the cooling chambers.

The rubber ring is too large for the application. Either it has
swelled, or the previous owner installed the wrong size. There is too
much 'slack' in the ID and the ecentric will does not touch the
rubber. Also, the OD fits tight against the housing.

Can anyone tell me where I might purchase the correct size pump for
this model? Are there outlets for these old parts? Does any one have
a manual on this model?

I called a friend who is an expert on these small antique outboards
and he was sure it was a Clinton. He said it was possible it could be
an OMC, but was pretty sure it was a Clinton.

Call these folks and give them a try - can't guarantee results though.

Clinton Engine Corp
605 East Maple St
Maquoketa Iowa 52060
319 652 2411

Good luck.

Later,

Tom

"Beware the one legged man in a butt
kicking contest - he is there for a
reason."

Wun Hung Lo - date unknown