Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
ANDY PHILLEY
 
Posts: n/a
Default Negative flow causing pitting in aluminum?

I have a 2002 Smokercraft. I was doing some testing for my
downriggers and I noticed I have a negative flow through my boat. Is
this normal? I found this by un-hooking my negative lead from the
battery. I then hooked a test light between the post and the hull and
it lit up. Do I have a problem? I also have some small pitting above
the waterline, could this be linked?
  #2   Report Post  
IBNFSHN
 
Posts: n/a
Default

You would find the same thing if you tested that way on the positive side.
Either something is turned on, something normally running, or you have a
short somewhere.
As for the pitting, it may be due to no or wrong sacrificial anodes
installed.

--
Bill
Chesapeake, Va


"ANDY PHILLEY" wrote in message
om...
I have a 2002 Smokercraft. I was doing some testing for my
downriggers and I noticed I have a negative flow through my boat. Is
this normal? I found this by un-hooking my negative lead from the
battery. I then hooked a test light between the post and the hull and
it lit up. Do I have a problem? I also have some small pitting above
the waterline, could this be linked?



Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Chainplate pitting corrosion joe anglim Boat Building 10 November 22nd 03 09:05 PM


All times are GMT +1. The time now is 07:53 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 BoatBanter.com.
The comments are property of their posters.
 

About Us

"It's about Boats"

 

Copyright © 2017