I have a 14 ft. Carolina Skiff that does everything right...except...get up
"on to plane "quickly.

I recently traded in her older 25 hp Johnson, equipped with a Stainless
steel prop, for a newer 25 hp Mercury. The Mercury came with, obviously, a
different plain aluminum prop. I have not discarded the idea that the prop
may be the answer to my puzzle...

Previously, with the older Johnson, the boat would plane out in a very short
time. I run her in West Galveston (TX)bay flats, and that means running,
most of the time, in 9 inches or so of water. With the older engine, I had
NO problem getting her up and running in very shallow water.

The new motor (25 hp mercury) doesn't get her up as fast last as the older
engine. It is entirely possible that the pitch of the "standard" prop is not
sufficient to give me a "hole shot" that the older one did.

I will probably bring the new prop in for adjustment.

I did, however, have the idea that I could simply build a few L shaped hull
extensions that would act as permanent trim tabs, and that might solve the
"getting up" problem permanently, and even add a little speed. The
extensions might eliminate re-working the prop.

Any thoughts or comments from this group would be appreciated.

RichG