On 4/23/2010 8:51 AM, Loogypicker wrote:
On Apr 22, 4:26 pm, wrote:


No one as dumb as you
are, and with your perseveration and blinders problems can be much of a
thinker. As you prove here daily.

--
Well, then please do explain your previous diatribe about heat
dissipation. Especially the remark about grease "spreading the heat
around".




Loogie,
Did you miss this gem. If he is going to lie, he should, at least, try
to be consistent. Was it two courses or three? I wish he'd make up his mind.

As a point of fact, I did take a couple of university engineering course
when we lived in Florida. From those three courses, I am sure I have
more formal engineering education that you do.

On Apr 23, 9:31*am, anon-e-moose wrote:
On 4/23/2010 8:51 AM, Loogypicker wrote:

On Apr 22, 4:26 pm, *wrote:

*No one as dumb as you
are, and with your perseveration and blinders problems can be much of a
thinker. As you prove here daily.

--
Well, then please do explain your previous diatribe about heat
dissipation. Especially the remark about grease "spreading the heat
around".

Loogie,
* * * * Did you miss this gem. If he is going to lie, he should, at least, try
to be consistent. Was it two courses or three? I wish he'd make up his mind.

As a point of fact, I did take a couple of university engineering course
* when we lived in Florida. From those three courses, I am sure I have
* more formal engineering education that you do.

OK, I was curious to go measure them. ID =.63" and OD of the race is
1.36". KMS bearings, Anaheim, CA. They are really cool.

On Fri, 23 Apr 2010 09:32:44 -0700, Frogwatch wrote:


OK, I was curious to go measure them. ID =.63" and OD of the race is
1.36". KMS bearings, Anaheim, CA. They are really cool.

Wheel chair???