| Home |
| Search |
| Today's Posts |
|
#5
posted to rec.boats
|
|||
|
|||
The transom repair saga update
Wayne.B wrote:
On Mon, 2 Feb 2009 09:53:03 -0800 (PST), wrote: The area where I had the screws to set the level did come out well and that's the most important point since the outdrive will sit on that. Next I'll mix up some more gelcoat and trowel it into the low spots. You could rough it up and fill with low density fairing compound, even bondo if you store out of the water. Sand it flat, apply gel coat and it should look great. Gel coat is brittle and it will crack if you get it too thick using as a filler. Remember to turn the boat so the pointy end is facing towards the earth. -- Looking to for a good time? click here to make yourself feel good. http://tinyurl.com/d3vxvm |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Next on the Transom Repair | General | |||
| Transom repair in Sacramento area | General | |||
| transom repair | Boat Building | |||
| Transom repair | General | |||
| transom repair | General | |||
![Reginald P. Smithers III, Esq.[_4_] is offline](https://www.boatbanter.com/images/SultanThemeVB3R/statusicon/user_offline.gif)
Threaded Mode
