Home |
Search |
Today's Posts |
#12
|
|||
|
|||
"Steve" wrote in message ... All, Thanks for the replies. It should mention that just about all the wire I am working on at the moment is internal to the boat. I think I will continue to use the untinned wire (bargains on marine cable are not common in NZ) but seal the ends as suggested. I am aware of the issue with fatigue if the copper is too thick and so will use something with lots of thin strands. I also solder all the small crimp connectors as well as crimp them which I believe will offer some protection. From what I have read, solder and crimping is not a good idea. Soldering is not neccesary when using a proper crimp connector. Soldering has a number of drawbacks. A good crimp connection that is sealed against moisture is about as good as it gets. For the nav lights (front, back and mast) I an leaving the existing wire in place as it is tinned and in excellent condition. Thanks again, Steve |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Mercruiser alternator wire overheating - engine stops - tip | General | |||
If you have to solder | Cruising | |||
Source for cheap tinned marine battery cable | Boat Building | |||
Battery wire | Electronics | |||
Battery wire | Electronics |