| Page 2 of 2 | 1 | 2 |
|
|
GTO-15 is primarily used in wiring neon signs and oil burner igniters. It
is a single 14 gauge stranded conductor incased in a thick Polyethylene or PVC insulation. A little over 1/4" in diameter. Check with a neon sign shop. They will probably give you 15' or at least sell it sans the "marine" label for a lot less than a chandler will. It is exactly the same thing. BTW, it should not be taped directly to the lower uninsulated section of the backstay. Mount it with some 2-3" standoffs. Some very neat standoffs can be made from 1/2" plastic conduit. Drill it the diameter of the backstay every 2" and cut it apart through the holes. Use black zip ties through the conduit and around the stay and wire to mount them. Another hint. Run the wire above the connection point and then back down to the clamp. That will keep water from soaking under the insulation and causing corrosion. I saw a really nice installation at the Annapolis show. It was a continuous black plastic extrusion that had a tube on one side for the wire to run through and snapped onto the stay on the other. Unfortunately nobody could tell me where it came from. "Martin" wrote in message ... "Glenn Ashmore" wrote in message news:l%tcd.32504$cN6.16187@lakeread02... Pull out the coax and replace it with GTO-15 high voltage wire. Where in the Uk would I buy GTO-15 wire? |
|
It is OK to parallel the GTO-15 to the lower part of the backstay
as long as the lower portion of the backstay is not grounded (ie part of a bonding system). If the lower part of the stay cannot be isolated for some reason, then the standoffs are requires. Doug s/v Callista "Glenn Ashmore" wrote in message news:uvPcd.74175$tU4.40048@okepread06... GTO-15 is primarily used in wiring neon signs and oil burner igniters. It is a single 14 gauge stranded conductor incased in a thick Polyethylene or PVC insulation. A little over 1/4" in diameter. Check with a neon sign shop. They will probably give you 15' or at least sell it sans the "marine" label for a lot less than a chandler will. It is exactly the same thing. BTW, it should not be taped directly to the lower uninsulated section of the backstay. Mount it with some 2-3" standoffs. Some very neat standoffs can be made from 1/2" plastic conduit. Drill it the diameter of the backstay every 2" and cut it apart through the holes. Use black zip ties through the conduit and around the stay and wire to mount them. Another hint. Run the wire above the connection point and then back down to the clamp. That will keep water from soaking under the insulation and causing corrosion. I saw a really nice installation at the Annapolis show. It was a continuous black plastic extrusion that had a tube on one side for the wire to run through and snapped onto the stay on the other. Unfortunately nobody could tell me where it came from. "Martin" wrote in message ... "Glenn Ashmore" wrote in message news:l%tcd.32504$cN6.16187@lakeread02... Pull out the coax and replace it with GTO-15 high voltage wire. Where in the Uk would I buy GTO-15 wire? |
| All times are GMT +1. The time now is 06:50 PM. |
|
Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 BoatBanter.com