MLR power cable mods
 

Hi

I want to take the output of my MLR into my Furuno 4100. I've worked out the
pin configurations and it looks like I can access the cabling / circuit
inside my 12V power cable.

Essentially the cable to the back of the MLR connection is wired for all the
pins and they terminate on a little board inside a match box sized case.

I can access the cable directly or , I guess, solder to the matching holes
on the other side of the circuit board, using the power cable config as a
guide.

Just looking for any pointers if anyone's done it.

Cheers

stephen