x-no-archive:yes


anon wrote:

On Mon, 22 Dec 2003 19:05:17 GMT, wrote:

Sorry 'bout that. All of the sailing boats I've been around had poles
so somehow assumed that everyone did.

We didn't have one, but Bob made one and installed it on the front of
the mast so we use it as you suggest.

http://www12.virtualtourist.com/m/tt/31714/#TL is a picture of him
doing that.

We rarely - almost never - use it to pole out the head sail (and we
have a yankee jib), but we use it a lot for dinghy launch and
retrieval.

One comment on your design. Those one inch dowels aren't going to be
very strong and if "poly-piping" is PVC piping it doesn't have much
strength. With my setup, initially the spinnicker pole is just about
horizontal in order to reach far enough out to lift the dinghy
horizontally (level) and have sufficient clearence to avoid bashing
the topsides of either vessel against the other. This puts some pretty
high loads on the pole. I'd do some testting to be sure that one inch
dowel would be strong enough.



On Mon, 22 Dec 2003, anon wrote:

wrote:

I assume that you are using this dinghy with a sailboat?

yes

If so use the spinnicker pole as a derrick. connect the
pole to the mast; connect the pole lift and rig a two,
three, whatever, part tackle between the pole and then
dink. You probably should also rig for and aft lines to
the end of the pole to control swing while you're hauling
the dinghy. Cheers . . .

Of course, I agree with this . . . if one has a spinnaker or like
pole. As it happens (actually: it didn't just "happen" and instead
for us was a matter of choice), we don't, having opted instead for a
near functional equivalent to a spinnaker or gennaker but with (for
us) more ease-of-handling yet don't-give-up-performance features
(i.e., Doyle's self-furling "utility power sail" a/k/a "UPS")). My
earlier suggestion, quoted in part below, thus is correspondingly
meant to (and does) perform exactly the functions in pretty much the
same manner as use of a spinnaker pole you summarize above yet also
with more collapsable/stow-able ease.*

-----------------------
*
Three 1"-diameter dowels capped with poly-piping
at the end acting as collars which, when slotted
together, make pole which can be attached
at one end to the mast, held up near the other
end with a spare halyard, and with pulleys at the
over-the-water end (and, again, [acts as a "derrick"
and] which when done can be removed and stowed
conveniently).

Cheers,

anon
(reply to k4556[at]inet[dot]co[dot]th)

grandma Rosalie

S/V RosalieAnn, Leonardtown, MD
CSY 44 WO #156
http://home.mindspring.com/~gmbeasley/id2.html