Bottom paint Q
 

When bottom paint is rolled on, you get an orange peel effect. Doesn't
this add to the wetted surface? Also, how do you burnish bottom paint?
Thanks
Gordon

Bottom paint Q
 

"Gordon" wrote:

When bottom paint is rolled on, you get an orange peel effect. Doesn't
this add to the wetted surface? Also, how do you burnish bottom paint?

Depends on what kind of bottom paint it is but for the kind that
sloughs off and the growth with it -- You don't (burnish)

If you are racing or something where the smoothness of the bottom
matters, you don't use that kind of bottom paint and then you either
take the boat out of the water and wash the bottom off when it isn't
being used, or have someone scrub the bottom while it is in the water.

Bottom paint Q
 

Thanks. That's what I was looking for.
G
"Rich Hampel" wrote in message
...
Using a roller produces a lot of orange peel. The orange peel results
in higher drag, provides a better footing for slime and the inevitable
growth.
I use ablatives on my 'kroozer' but I get a babies ass smooth finish
with minimum extra effort with the following method. A smooth bottom
is FASTER, lasts longer and releases slime and growth easier.

Process (for ablatives):
Materials: 1/8" foam roller (I use WEST System epoxy rollers), large
polyethylene trowels (WEST SYSTEM yellow trowels)
Roughly flat sand (100 grit) the bottom but leaving 'bottoms' of the
previous orange peel. The object is create FLAT tops to the 'bumps'.
and you 'fill-in' the valleys with the trowel. Doesnt take much
sanding, a 40 footer can so sanded in about 1/2 hour.
Apply the paint in a two foot wide 'stripe' with a 1/8" foam roller,
then immediately wipe the surface with the trowel (just like how you
work a plastic trowel when fiberglassing). The trowel will wipe the
paint off the 'tops' and begin to fill the valleys. Always work to a
wet edge, never go back into the wet once you draw the trowel. Leave a
1 or 2 ft. dry space and do the next stripe, in the same manner until
the boat is covered. Let dry, then fill in the missing areas between
the stripes, Let dry completely - a day or so.
Repeat, but make the stripes, etc. at a different angle from the first
set ... do the whole hull. Let dry a few days.
Repeat using horizontal stripes, etc.
By now the hull will be almost babies ass smooth.

Keep the trowel clean by occasionally wiping with a rag soaked in paint
solvent.


In article , Gordon
wrote:

When bottom paint is rolled on, you get an orange peel effect. Doesn't
this add to the wetted surface? Also, how do you burnish bottom paint?
Thanks
Gordon

Bottom paint Q
 

On Mon, 07 Aug 2006 04:42:27 GMT, Rich Hampel
wrote:

Repeat using horizontal stripes, etc.
By now the hull will be almost babies ass smooth.

Keep the trowel clean by occasionally wiping with a rag soaked in paint
solvent.

That's a good approach. A real racing fanatic will then wet sand the
bottom with 220 and 400 grit wet and dry paper using long rubber
blocks to hold the paper, and working in an "x" pattern of strokes.
We used to put a small amount of detergent in a bucket of water to
keep the paper from clogging. You know you've got the bottom just
about right when you can spray it down, and have the water hang in a
smooth sheen reflecting like a mirror. It makes an incredible
difference in light air.