chrysler nissan 105hp 6?
I'm tending and outfitting an Islander Freeport with the above engine.
I rebuilt a couple of diesels years back. Hopefully I'll get her running this weekend. Other than the obvious I have very little knowlege of this motor and I haven't been able to Gooogle up much... someone said parts are difficult/impossible to find, "yank 'em immediately! don't want to be stuck for want of a part", But it's a shame to waste such a piece of iron ( fresh rebuild on the injector pump! ). Can any one throw me some pointers? Are there many of them out there? Specs? Surely the starter motor cross refences to other motors. Ways to fabricate/modify other parts? ta, |
chrysler nissan 105hp 6?
This is a very common engine that uses many common parts. Chrysler marketed
this as a marine engine in the US, but it was sold all over the word for vehicle power in trucks and buses as well as generators. Any Bosch service center will service the injectors and PT pump. I use one as a generator engine. Forget Chrysler as a service source. Use Nissan Motors. The flywheel housing is generic as well as all the accessories. I converted mine to 24 volt. What problem. Steve "wblakesx" wrote in message ups.com... I'm tending and outfitting an Islander Freeport with the above engine. I rebuilt a couple of diesels years back. Hopefully I'll get her running this weekend. Other than the obvious I have very little knowlege of this motor and I haven't been able to Gooogle up much... someone said parts are difficult/impossible to find, "yank 'em immediately! don't want to be stuck for want of a part", But it's a shame to waste such a piece of iron ( fresh rebuild on the injector pump! ). Can any one throw me some pointers? Are there many of them out there? Specs? Surely the starter motor cross refences to other motors. Ways to fabricate/modify other parts? ta, |
chrysler nissan 105hp 6?
Thanks again Steve. Can you point me to generic suppliers? The starter
for instance seems a little dodgy and it would be nice to have spares aboard. |
chrysler nissan 105hp 6?
On 5 Oct 2005 21:23:43 -0700, "wblakesx" wrote:
I'm tending and outfitting an Islander Freeport with the above engine. I rebuilt a couple of diesels years back. Hopefully I'll get her running this weekend. Other than the obvious I have very little knowlege of this motor and I haven't been able to Gooogle up much... someone said parts are difficult/impossible to find, "yank 'em immediately! don't want to be stuck for want of a part", But it's a shame to waste such a piece of iron ( fresh rebuild on the injector pump! ). Can any one throw me some pointers? Are there many of them out there? Specs? Surely the starter motor cross refences to other motors. Ways to fabricate/modify other parts? ta, I have the 62 hp 4 cylinder version and like it a lot. I have never had any problem getting parts from local diesel supply stores. If you have any problem with parts, let me know and I will send you the address of my supplier in Padacha, Kentucky. If you decide to yank your 105, just send it to me. Lee Huddleston s/v Truelove |
All times are GMT +1. The time now is 06:00 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 BoatBanter.com