spring maint. suggestions?
 

"Ryk" wrote in message
...
Or better still, remove the impeller and let it sit round and
unstressed when the boat is layed up for the winter. If nothing else
it guarantees an annual inspection.

But store it under water or put some vaseline on it, to prevent the rubber
of drying out and becoming brittle.

Meindert

spring maint. suggestions?
 

Meindert Sprang wrote:
"Ryk" wrote in message
...

Or better still, remove the impeller and let it sit round and
unstressed when the boat is layed up for the winter. If nothing else
it guarantees an annual inspection.


But store it under water or put some vaseline on it, to prevent the rubber
of drying out and becoming brittle.

Meindert

Well, the new ones sit out in the box, and they don't seem to dry out. The rebuild kit that I've
got is sitting on the shelf, and the impeller is just packed loose in the box. I suppose that after
a long time they might harden up, but I don't think that Mercury puts any "shelf life" on them.

Don W.

spring maint. suggestions?
 

Don W wrote in
m:


Well, the new ones sit out in the box, and they don't seem to dry out.
The rebuild kit that I've got is sitting on the shelf, and the
impeller is just packed loose in the box. I suppose that after a long
time they might harden up, but I don't think that Mercury puts any
"shelf life" on them.

Don W.


I think the torque pushing sideways on the rubber is what destroys them.
Let's face it, all these pumps are cheap pieces of crap, as cheap as they
can get away with. Hell, I got one that fits on the end of my drill. It
retails for $6.

Wonder why we couldn't get a self-priming pump without breakable rubber
parts for $12,000, the cost of a big outboard motor with no transmission,
no wheels, no suspension system, no passenger cab, no radio, no A/C, no
heater, no lights, no trunk, damned little painted surfaces and made of pot
metal.....??

Even for $2,200 for a 3hp, single-cylinder, 2-stroke outboard with the
simplest engine in the world, we should be able to get a pump made of
STAINLESS METAL PARTS, shouldn't we?

Larry