Thanks Guys - You really helped a lot
A while back there was a discussion here about making a nice round hole
bigger. One solution that was suggested was to get a special hole saw that allowed you to use a smaller longer bodied hole saw in the middle as a pilot and the larger new correct size hole saw on the out side. I had to change to a sink faucet yesterday, and the fancy one my wife picked out would not reach all the way through the multiple layers of the counter top. With tile on top, a layer of unknown material, the sink itself, and then a layer of plywood below it was just too much material. I dug through the box of hole saws in my truck and noticed that different diameters and brands were of different lengths. When I looked at my arbors I noticed one had longer threads than the rest. I selected a hole saw that was the same diameter as the existing hole, and one that was a little larger than the outside diameter of the nut that would tighten the faucet in place. I screwed on the larger hole saw, and then the smaller one. It looked perfect, and ultimately it was. I cut a hole through the bottom layer of plywood up to the bottom of the sink itself. It worked like a charm. Everything is in place and all nice and solid and sealed. Being in the trades I probably would have eventually figured out a way to do this, but thanks to everybody here I was able to instantly formulate a solution. You guys made me look like a hero. Thanks guys. Bob La Londe www.YumaBassMan.com |
All times are GMT +1. The time now is 09:54 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 BoatBanter.com