YSTay wrote:
Hello,
anyone here with experience applying flock? I am about to get hold of a
flocking unit but have never done it before. I intend to apply the flock
fibres (electrostatically) while the fiberglass parts are still wet and in
the mold using the polyester resin as the glue. Any problems with this?
All help appreciated. TIA

Arnold



I once worked at a place that flocked floor mats. These were done by
machines but they also had hand held devices for prototype work. Mostly
plastic, insulated, containers that held the flock and a high voltage
positive electrode. The flock was shaken out onto a mat where a thin
coating of glue had been applied in certain areas. Under the mat was
the high voltage negative electrode. The high voltage would make the
flock fibers stand on end instead of just laying flat. The voltage I
think was somewhere around 30 or 40 thousand volts. I once made them an
improved model that worked much better than the store bought ones by
using a Tesla coil kit.

Donald

--
I'm building a Steel Robert's 434. You can sneak a peek if you wish by
clicking on me link below.
http://bellsouthpwp.net/d/o/donrayp/
'USA, Home of the best
politicians money can buy'