Home |
Search |
Today's Posts |
#4
|
|||
|
|||
One trick is to braze a drill bit of the correct diameter to a length (12"
??) of "music wire." (Groove the dull end of the bit so the wire comes out centered and adjust with a hammer.) Guide the bit with heavy gloves or a bit of tube slipped over the wire. Works well for small bits. Haven't tried anything larger than 1/4". You can also spend big bucks at http://www.aircraftspruce.com/catalo...angledrill.php Roger http://home.earthlink.net/~derbyrm "Chris" wrote in message oups.com... I saw at the Miami boat show a salesman demonstrating an adaptor that when attached to the drill you could adjust the angle of the drive more than just a 90 degree fitting. (Should have bought it) I need to drill into the coaming through heavy glass and tap into a metal backing plate and the bottom holes clearance is less that 1 1/2" above the deck. Any suggestions out there?? Thanks, Chris |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
NY Go Kart Endurance Racing - Arrive & Drive - No Experience Needed | General | |||
NY Go Kart Endurance Racing - Arrive & Drive - No Experience Needed | Power Boat Racing | |||
NY Go Kart Endurance Racing - No Experience Needed - Arrive & Drive | Cruising | |||
B&D 24v Firestarter Cordless Drill | ASA | |||
GAULEY FESTIVAL VOLUNTEERS NEEDED | General |