BoatBanter.com

BoatBanter.com (https://www.boatbanter.com/)
-   Boat Building (https://www.boatbanter.com/boat-building/)
-   -   DIY steering for 14 foot AL (https://www.boatbanter.com/boat-building/35285-diy-steering-14-foot-al.html)

[email protected] April 23rd 05 11:38 AM

DIY steering for 14 foot AL
 
HI I have a 14 foot Al boat. I want to install seats probably just the
canadian tire special. but is dumb to put steering on a small boat...I
have a johnson 6 i cant seem to find plans for steering on the internet
just kits and books....

cheers

maybe i can post a picture


Roger Derby April 23rd 05 01:51 PM

Run a line around the perimeter of the crew space with eyes for fairleads
and secure the ends to the tiller. From anywhere in the boat, you can
adjust the helm and if there's enough friction, it stays where you leave it.

Probably won't work for Miss Budweiser, but it answered quite well for a
sailing kayak I messed with in high school.

Roger

http://home.earthlink.net/~derbyrm
wrote in message
ups.com...
HI I have a 14 foot Al boat. I want to install seats probably
just the canadian tire special. but is dumb to put steering on
a small boat...I have a johnson 6 i cant seem to find plans for
steering on the internet just kits and books....

cheers

maybe i can post a picture




William R. Watt April 23rd 05 03:06 PM


You can bolt a vertical tiller to one gunwale with the lines running back
along the same side to the motor. TF Jones describes how to do it in one of
his books in the chapter on narrow powerboats.

We used to use an extension right on the handle of the motor.

--
------------------------------------------------------------------------------
William R Watt National Capital FreeNet Ottawa's free community network
homepage: www.ncf.ca/~ag384/top.htm
warning: non-FreeNet email must have "notspam" in subject or it's returned

Ian Malcolm April 25th 05 12:04 PM

William R. Watt wrote:
You can bolt a vertical tiller to one gunwale with the lines running back
along the same side to the motor. TF Jones describes how to do it in one of
his books in the chapter on narrow powerboats.

Or use a whipstaff (stick pivoted to hog, steering lines half way up the
stick, push the top the way you want to go) N.B. unless you cross the
lines at the transom, the action *will* be opposite to that of the
engine's tiller


We used to use an extension right on the handle of the motor.

Gets in the way a lot and you cant do any tight manouvers easily. I
prefer the improvised twin rope steering. Have operated a rig like that
for about 50 hours while the proper safety boat was U/S (maintenance).
There was negligable slop in the steering and what there was was
easily removed just by pulling the steering bar gently towards you. The
twin cord remote throttle hookup was rather less satisfactory, I'd
reccomend fitting/adapting a proper control for that.

--
Ian Malcolm. London, ENGLAND. (NEWSGROUP REPLY PREFERRED)
ianm[at]the[dash]malcolms[dot]freeserve[dot]co[dot]uk
[at]=@, [dash]=- & [dot]=. *Warning* HTML & 32K emails -- NUL:
'Stingo' Albacore #1554 - 15' Early 60's, Uffa Fox designed,
All varnished hot moulded wooden racing dinghy.


All times are GMT +1. The time now is 08:18 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 BoatBanter.com