|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 5th 03, 01:41 AM
|
|||
|
|||
Volvo Penta aq125a firing order
Does anyone know the firing order on a aq125a.....Its a 4 cylendar
inline volvo penta 1984 in a Bayliner Capri. The manuel says its 1-3-4-2....But it also shows it rotating counter clockwise. Mine rotates clockwise? Whats up with that? Any help? Also with the #1 cylendar at TDC, I assume the timing marks should be aligned on the flywheel and the dist rotor should be pointed at the #1 lug. Correct? 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Volvo Penta outdrive question | tonycougar | General | 4 | October 8th 03 04:24 PM |
| Volvo penta starts without key in the ingintion | Todd Fleming | General | 4 | July 24th 03 04:18 AM |
| Volvo Penta (EFI) engine starting problem | Larry Buss | General | 0 | July 19th 03 06:19 AM |
| v-belts volvo penta 3.0 gs | Calif Bill | General | 0 | July 14th 03 06:27 AM |
| Prop advice for Volvo Penta | Joseph | General | 2 | July 11th 03 02:17 AM |
Linear Mode
