Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Oil drain hose kits?
Does anyone have any experience, good or bad, with oil drain kits where
you attach a fitting/hose to your oil pan's drain plug? For example the one shown in the link below: http://www.overtons.com/cgi-bin/over...il.cgi?26164++ Seems once this is installed, oil changes would be a breeze since you would not have to deal with trying to suck oil out of the dipstick tube Thanks! Bob |
#2
|
|||
|
|||
Oil drain hose kits?
Speaking of making oil changes easier, my Merc 165 has a spin on filter
stuck on the side. It's the white thing on the left in this photo: http://users.adelphia.net/~blizzard3...ges/engine.jpg Is there any easy way to change that without making a mess? |
#3
|
|||
|
|||
Oil drain hose kits?
I stick a plastic disposable paint roller tray cover under my oil filter
before I remove it. Small enough to fit under everything, big enough to catch drips, and really cheap. "Joe Blizzard" wrote in message ... Speaking of making oil changes easier, my Merc 165 has a spin on filter stuck on the side. It's the white thing on the left in this photo: http://users.adelphia.net/~blizzard3...ges/engine.jpg Is there any easy way to change that without making a mess? |
#4
|
|||
|
|||
Oil drain hose kits?
"bomar" wrote
I stick a plastic disposable paint roller tray cover under my oil filter before I remove it. Good thinkin'. I use an old cookie sheet under the engine when I change oil. It keeps it from dripping into the bilge, but I still have clean up the block and oil pan where it runs down the side from the filter. It's not as bad as my Taurus, which has a frame member directly under the filter so that oil runs down the frame and drips over an area that's bigger than any of the pans I have. |
#5
|
|||
|
|||
Oil drain hose kits?
Punch a hole in the top before you change it. That will allow at least some
of the oil to drain back into the engine. Then loosen it, wrap a Ziploc bag around it with some paper towels inside, then unscrew it and let the remaining oil drain into the bag, then seal it up and trash it. -- Keith __ If you must pick between two evils, pick the one you've never tried before. "Joe Blizzard" wrote in message ... Speaking of making oil changes easier, my Merc 165 has a spin on filter stuck on the side. It's the white thing on the left in this photo: http://users.adelphia.net/~blizzard3...ges/engine.jpg Is there any easy way to change that without making a mess? |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Hose off, now Thruhull problem! | General | |||
How do I get a hose on a fitting? | General | |||
Place in Vancouver to plumb my holding tank? | General |