Thread: 5200 Removal
View Single Post
  #8   Report Post  
Mac
 
Posts: n/a
Default

On Wed, 15 Dec 2004 11:19:18 -0500, Marc wrote:

If
it were a smooth surface, I could probably use some kind of rubbing
tool. However, the foot prints are on the molded in anti skid
(diamond pattern). What about mild heat (hot air) and a stiff brush?


I was going to suggest a sharp chisel. But the non-smooth surface rules
that out.

I would definitely try the hot air and brush approach as I seem to
remember that 5200 doesn't like getting hot at all.

Let us know what happens.

--Mac