View Single Post
  #1   Report Post  
posted to rec.boats.building
CS[_3_] CS[_3_] is offline
external usenet poster
 
First recorded activity by BoatBanter: Oct 2009
Posts: 4
Default NPT and BSP taper threads

I am looking at getting some water filters, 20 inch housings, with 3/4
inch NPT female connections in plastic tops. Can I get away with
screwing in 3/4 BSP TAPER male brass compression fittings, using a
good wind of PTFE tape??
Both NPT and BSPT are 14 TPI and the nominal NPT is 1.050 inch OD and
BSPT is
fractionally smaller at 1.041 inch OD, so should fit in. I know that
there is a 5 degree difference between thread angle.

TVMIA