View Single Post
  #16   Report Post  
Ed Edelenbos
 
Posts: n/a
Default Resin Injection into soft wood

"DSK" wrote in message
...
"Ed Edelenbos" wrote
Hmmm.... I guess it must be different for working people. I've known
several boat yard operators and pile drivers who use this method (for
their own boats). Actually, the most common way is to use regular epoxy
resin and thin it with acetone to the right consistency. I know of a
couple rib repairs that are about 25 years old and still in place.



It depends very much on what the original structure was like (ie massive
workboat construction or slender scantling yacht type); and what stress
it's put under.


This is exactly what I said... it depends on the task. For the statement
"Unless the part is reinforced with carefully aligned glass fiber it will
not be up to the task." to be made, it assumes that either it is unsuitable
for ANY task, or that ALL tasks are the same. Neither of these assumptions
are correct.

I'll stand by what I said... it is a rediculous assertion.

Ed